Standard Casting Tubes

* DUE TO THE INCREASED WEIGHT OF CASTING TUBES AND LINERS ADDITIONAL SHIPPING CHARGES MAY BE REQUIRED.*
Please Note !!
Standard Casting Tubes and Liners will not fit Aerotech 38mm, 54mm,98mm Motors or 38mm Gorilla hardware.
 We have also added a category of 75mm and 98mm Casting Tubes and Liners for Mike Fisher Motor Hardware.

The Specification table below is subject to change without notice.

38mm  Standard	Liner: 1.323 OD x 1.269 ID with a .027 Wall Casting Tube: 1.252 OD x 1.212 ID with a .020 Wall
54mm Standard	Liner: 1.917 OD x 1.837 ID with a .040 Wall Casting Tube: 1.825 OD x 1.775 ID with a .025 Wall
75mm Standard	Liner: 2.734 OD x 2.612 ID with a .061 Wall Casting Tube: 2.596 OD x 2.536 ID with a .030 Wall
98mm Standard	Liner: 3.486 OD x 3.336 ID with a .075 Wall Casting Tube: 3.319 OD x 3.239 ID with a .040 Wall
152mm 6 inch (1/4" wall hardware)	Phenolic Liner 5.448 OD x 5.198 ID with a .125 Wall Phenolic Casting Tube  5.188 OD x 5.014 ID with a .087 Wall
75mm Fisher Research	Liner: 2.749 OD x 2.612 ID with a .061 Wall Casting Tube: 2.596 OD x 2.536 ID with a .030 Wall
98mm Fisher Research	Liner: 3.495 OD x 3.336 ID with a .075 Wall Casting Tube: 3.319 OD x 3.239 ID with a .040 Wall

All casting Tubes and Liners are sold in 4′ lengths.
For partial and blemished lengths of Casting Tubes check out “Bits & Pieces”.

We recommend that all 38mm and 54 mm casting tube sets be cut in half to reduce possible shipping damage. If you want us to cut them, place a note in the customer notes section of the checkout page.
If you choose not to have them cut, it will be your responsibility to file a claim for any damage caused by the Carrier.